Supermicro 2500W/2000W C19-C20 Power Cord Mã sản phẩm: CBL-0223L
- Output Connections : (1) IEC 320 C19
- Input Connections : IEC-320 C20
At the current time, the Supermicro® SuperBlade® is shipping with power supplies of 1620 Watts or larger. In order to supply adequate power for the SuperBlade system, your site should provide 30 Amps of 200-240V power for every pair of power supplies that are installed in your SuperBlade chassis.
Although the Power Distribution Unit (Figure 3) that is recommended by Supermicro supports up to four power connections, only two connections should be made to each PDU. The PDU has a Nema L6-30 connector plug that can plug into a Nema l6-30 socket (Figure 4). Each PDU, supporting two power supplies must be plugged into a separate circuit that provides 30 Amps of power and a voltage ranging from 200-240V.
Table 1 below illustrates the various Power Supplies offered by Supermicro.
Table 1 - Power Supply Amperage Draw
Supermicro SuperBlade® productincludes a power extension cord CBL-0223L for 2500/2000W (Figure 1) or CBL-0248L for 1400W/1620W (Figure 2) system. The power cord typically connects the power supply to a Power Distribution Unit (Figure 3 - optional PDU) in an IT room. The PDU should supply input voltage ranging from 200V to 240V AC. As stated above, the circuit that the PDU plugs into should provide 30 Amps that is not shared by any other device.
Figure 1 -CBL-0223L 2500W/2000W Power Extension Cord
Figure 2 -CBL-0248L 1620W/1400W Power Extension Cord
Figure 3 - Power Distribution Unit (MCP-520-00036-0N) with NEMA L6-30 plug
Figure 4 - NEMA L6-30 Plug & Socket
Before beginning receptacle installation, consider the following:
- Observe all local electrical codes and practices.
- Ensure that the AC power receptacle is wired to the site AC power via conductors routed through flexible metal conduit or via approved AC power cable before installation.
- Ensure that AC power cord is properly sized, service rated, temperature rated, and complies with all applicable codes and regulations.
- Ensure that the conductors in conduit are properly sized, service rated, temperature rated, color coded, and comply with all applicable codes and regulations.
- Ensure that the AC power cord or conduit is long enough to reach from the site AC power junction box to a location within the distance required for the connection.
- Ensure that the AC power cord or conduit is long enough to reach from the site AC power junction box to a location within the distance required for the connection.
- Ensure that the number of power supplies connected to one circuit do not exceed the rated amperage of the circuit.
